Simple Deluxe PTCLAMCR150MCTRL 150W Reptile Heat Bulb & 150W Clamp Light with 8.5″ Reflector & Digital Thermostat Controller Combo Set, Black
Original price was: $39.99.$33.99Current price is: $33.99.
Price: $39.99 - $33.99
(as of Oct 30, 2025 08:25:59 UTC – Details)
Ceramic Reptile Heat Bulb:
Specifications:
Socket: E26;
Volt: AC 110-120V;
Watts: 150W;
Material: ceramic, NiCrAl;
Diameter of heating surface: 85mm;
Note: 1. Lamp surface temperature is too high, do not directly touch during it works; 2. Before remove it from fixture, please allow at least 1 hour for cool to avoid scald ; 3. Accidents may happen due to improper operation so please use it in a right way and avoid using in damp environment; 4. Please adjust the distance between the lamp and the pets, at least 35cm; 5. Please away from combustible or explosive materials；
Clamp Light:
Specification：
Volt: 120V;
Watt: Accepts up to 150W bulb (E26);
Reflector Diameter: 8.5 inch;
Cord: 6 feet;
18/2 SPT-2 cord clamp light can also be used as a table lamp in your room, garages or art studios, a work light in photography and workshops, amphibians and reptiles pets terrarium heat lamp, and even a growth light for indoor plants.
Warning: The power cord on this product contains chemicals, including lead known to the State of California to cause cancer. Wash hands after use.
Digital Thermostat Controller:
Specifications:
Temperature control range: 40℉-108°F;
Temperature display range: 32℉-140°F;
Rated Voltage: AC 120V 60Hz ;
Max Loading: 8A 1000W ;
Easy plug-in operation with LED illuminated indicator lights & three-prong ground plug. Digital thermostat can also be used to control the temperature of many other appliances as long as they don’t exceed the maximum electrical specifications stated above. Simply place the sensors in the area where the temperature needs to be controlled plug the appliance into thermostat, and set the desired temperature.
Abnormal Warning: 1. If thermostat shows “E1”, it means that the actual temperature is lower than 0℃ or 32℉; 2. If thermostat shows “E2”, it means that the actual temperature is higher than 60℃ or 108℉. 3. If thermostat shows “E3”, it means that the temperature sensor is not working properly. Please re-install the sensor；
Multifunction: great for reptile and amphibian terrariums, incubating poultry heater
Perfect 24h heat source: heat bulb does not emit any visually detectable light, would not disturb pets sleep. 150W, E26 lamp base. Material: ceramic, NiCrAl. To avoid scald, please wait at least 1 hour to cool down after turning off the bulb.
Multifunctional clamp light: scratch-resistant sleeves covered clamp would not leave marks on your surfaces, 360° adjustment and 8.5inch aluminum reflector can focus light where you need. Volt: 120V, Watt: 150W (E26). have convenient on/off button.
Temperature range: digital thermostat provides temperature control between 40-108℉, temperature display range: 32-140°F. Support Celsius or Fahrenheit readout. Volt: 120V 60Hz; Max Loading: 8A 1000W. Do not immerse controller or probe into water.
Package include: 1-pack 150W ceramic heat bulb, 1-pack digital thermostat (easy plug-in operation with LED illuminated indicator lights and three-prong grounded plug), 1-pack clamp light with 8.5 inch reflector.
Customers say
Customers find the heat bulb easy to use and set up, with good quality and value for money. Moreover, the functionality receives positive feedback, with one customer noting the thermometer works great. However, the temperature control receives mixed reviews, with some saying it maintains temperature while others report it doesn’t output enough heat. Additionally, durability and sturdiness are concerns, with multiple customers reporting that the dome falls off the base and the product broke within the first week of use.
13 reviews for Simple Deluxe PTCLAMCR150MCTRL 150W Reptile Heat Bulb & 150W Clamp Light with 8.5″ Reflector & Digital Thermostat Controller Combo Set, Black
Add a review
Related Products
Original price was: $39.99.$33.99Current price is: $33.99.
Keri –
Works great
Easy to set up a d use right away. I got this for my hedgehog ð¦ and it’s great. It keeps her cage at the perfect temperature and you can set the temperature and it will turn on and off by itself to the temperature you set.
Bucklipe –
Cooked chicks, NOT! EDITED!!!
See edit below:Tried offline… As a new unit I set it up in an empty brooder to test it. Tied the sensor 2″ off the floor, set the temperature to 102° and took readings. The temperature rose to 116° per the controller and verified with a handheld digital thermometer. Dropped to 100° and started heating. Two problems; temperature went too high and the heater plug just barely stays in the controller. It fell out three times. I expect better heat control from a digital controller… Another test: I set the controller to 95°, temperature went to 113° before it shut off. This time I put it in a cooler with the heater at one end and the probe set on a brick. The controller sits outside with the wires going inside. Too high of a temperature swing for a digital controller. My contact via email was totally unsatisfactory. “I would like to inform you that the probe should be attached to the surface where temperature needs to be monitored, probe wasn’t designed to measure the temperature of the air.” Thermisters measure temperature, whether in air or suction cupped to a surface. I guess I need to return it and buy from another supplier.Edit follows:I was sent a new unit and decided to test it in a cooler for better control of variables. I plugged it in, put a 40 watt incandescent bulb in as a heater, set it for 105degrees and turned the light on. In 5 minutes the air temperature rose to 105 degress and the unit turned off the light. The temps fell to 103 degrees and the unit powered up the light. Great, just what I wanted!I repeated the test with the 150 watt ceramic heater that came with the kit. We went off the rails… The temperature rose to 105 degrees, turned off and the temperature continued to rise to 135 degrees! Yikes! I did some further research and found that the ceramic heater went up to 500 degrees. It weighed 6 ounces at 500 degrees so it continued to contribute heat to the cooler air. BTUs are mass times heat rise divided by the air volume… I didn’t get the BTU thing done but my guess is that was 150 BTUs stored in the ceramic heater and as they dissipated the temps soared too high even though the power was off. The 40 watt bulb weighed .8 ounces and probably had a .1 BTU.The take away from this escapade? Don’t use a heavy, high watt heater when a light (no pun intended), low watt heater will do the trick.I retested the original controller with the 40 watt bulb and it was perfect.My apologies for not figuring this out before you sent me the replacement.With a heater sized to the task this controller is perfect!I think customer service might need to know about this issue so it can be addressed.Maybe have a redirect to their website to calculate the heater size needed before purchase?
Elliott –
Thermometer is good but the heat shield threading sucks
The heat shield worked for a day, and even then it was loose. Thermal expansion came around and just said no, so now it won’t stay on, even when I tried to use thermal tape. Now I bought this for the thermometer and the ceramic heat bulb but turns out that’s WAYYYYY too much for like a 10 gallon tank. So I figured I’d use it with a 80w bulb, which works with the other dome I already had. For the price, it’s worth it just for the thermometer cutoff part of the set. Se thing at pets mart would run between $50-$70, but if you’re going to get this for the heat shield/ceramic heat bulb part of it, look elsewhere. Maybe I’ll try to crimp the threads onto the fixture, I’m not sure. Either way it’s hardly worth countacting the company to send everything back over a crappy piece of aluminum. Will be keeping because of the thermostat/power supply combo which works fine.Thermometer is responsive with a decently high refresh rate on the screen, though the little plastic tip does insulate it, so be careful. You might think your Hotspot is only 90 degrees when in fact it’s closer to 110. For the power regulation part you just hold the “set” button for a few seconds until it starts blinking and then set the temp. The light that is plugged into it will not work until then. When it reaches the set temp, it shuts off and will stay off until the thermometer reaches a full 2 degrees below what it’s set to before turning back on. All of those features work pretty well. Only crap thing is the heat shield that goes on the fixture.Edit – changing my review from 3 to 4 stars. I threw a TON of that white non adhesive tape stuff that’s used to seal threads. Probably like 10-15 times around the threads and it’s holding for now which is nice since now I can take back the heat shield I bought at petsmart. That dome alone cost as much as this whole kit so overall not a bad deal at all. Will update if anything changes.
Nicole Lee Ann legendre –
Best heat lamp on Amazon
This lamp is perfect for hedgehogs! The thermostat keeps temp and the lamp heats without keeping him up with any light. For the price you canât beat this value!
Abby Lantz –
Recommend!!!
I absolutely love this heat lamp! It comes with a digital thermometer to keep track of the temperature⦠I used it for my hedgehog! Keep him warm and didnât get extremely hot and never had an issue with any burning smells or melting. I highly recommend this product for the fuzzy critter needing heat in your life.
K. Evans –
Really nice quality
I bought this set to use in my chicken coop, although I have a bigger bulb for heat, as this ceramic bulb would not suffice for the space. I plan to use the ceramic bulb in my tortoise’s winter enclosure. The temperature control module is exceptionally well made and far exceeds my expectations. The heat shroud is very large, suitable for any purpose, and durable. This is one of my best purchases and I thank the seller for offering a quality product at a reasonable rate.
MJ –
Works great. Kicks off whenever it reaches set temperature.
Works really well so far. It kicks off at the set temperature you set it for. Easy to read digital display.
S C –
It was ok, but didnât last long
I bought it last year 2021 for my hedgehog and a year later it exploded. The temperature was not consistent. Sometimes I would find the lamp cold even with the temperature set and showing it was on. Last month while cleaning my hedgehogâs cage, i sensed a weird smell coming from the lamp so while checking it I heard a explosion sound and the thermostat went off.
Mogwai –
Por el precio, no podrÃa haber pedido más. Incluye la campaña, el foco y termostato. Lo uso para mantener caliente a mi erizo. Es fácil de programar, resulta confiable. Ãnica recomendación es tener cuidado de mantener materiales que puedan derretirse o quemarse alejados de el foco ya que los quemará.
Christina –
Great socket, great ceramic bulb. No complaints from me or my bearded dragon after a few months of use
Wendell MacKinnon –
Use it in my chicken coop and it works really well. Easy to select temp and helps to maintain a minimum. In the winter, I set it to 12 Celsius.
So3415 –
Exactement ce que la description disait
Diego Flores –
Funciona bien, calienta bien y viene con una qbrazadera que termina siendo muy util